Installed inside conveyor transfer point skirtboards, MARTIN® DURT TAMER™ Wear Liner creates a dam to shield the sealing system from the weight of the material load, prolonging the life of the seal.

Straight wear liner is recommended in transfer point where impact or "bounce" of the material can lead to the entrapment of lumps between deflector liners and the chute wall. For ease of installation, MARTIN® DURT TAMER™ Wear Liner is available with pre-drilled and countersunk mounting holes.
Unit of Measure


Trough Angle

N/A 35 º


N/A Stainless Steel Wear liners have standard dimensions of 8 x 72 x 0.5 inches (203 x 1828 x 13 mm)
UHMW Polyethylene Wear Liners have standard dimensions of 6 x 48 x 1 inches (153 x 1219 x 25 mm)
Ceramic Faced Wear Liners have standard dimensions of 5 x 72 x 1 inches (153 x 1828 x 25 mm)
Other liner materials are available and wear liner can be ordered in custom sizes. For information, contact Martin Engineering.

Copyright © 2017 Airmatic Inc.,  All Rights Reserved