• Solid State Operation
  • 30mm Industry Standard Housing
  • Available in AC or DC
  • Easy Installation and Calibration
  • 2-year Warranty
The models PAC-30U and PDC-30 proximity switches are solid-state, point-level devices used to detect the absence or presence of bulk solids. The compact configuration makes this product ideal for tight spaces or low-cost level detection. As material comes in contact with, or in close proximity to, the PAC-30U or PDC-30, an internal solid state switch is activated. The PAC-30U is AC operated (20 - 265 VAC) and is universal in that it is switch selectable for either normally open or normally closed operation. The PDC-30 is DC operated (10 - 40 VDC) and is available in either PNP or NPN con figuration, each of which can be wired in either a normally open or normally closed operation mode.
Unit of Measure

Specifications

Operating Voltage

N/A PDC-30 (10-40 VDC)

Switching

N/A PNP

Housing

N/A Thermoplastic Polyester

Enclosure Protection

N/A IP67 (NEMA 4 equivalent)

Power Requirements

N/A 10-40 VDC

Mounting Thread Size

N/A M30 x 1.5

Sensing Distance (Adjustable)

N/A 4 to 25 mm

Indicators

N/A LED, yellow

Output

N/A 13-8231, NPN (sinking) 13-8241, PNP (sourcing)

Leakage Current

N/A < 10 mA

Load Current

N/A 0 to 200 mA

Frequency of Operating Cycle

N/A 100 Hz

Operating Temperature

N/A -13° to 176 ºF-25° to 80 ºC

Electrical Connection

N/A Cable, 6 ft (1.8 m), 18-20 AWG

Approvals

N/A CE Mark

Principle of Operation

N/A The PAC-30U and PDC-30 are RF capacitance-type level controls, which operate by detecting the electrical effect of the surrounding material such as air, plastic pellets or powders. A radio frequency is applied to the proximity switch sensing region and is continually analyzed to determine the influence of the surrounding environment. Since all materials have dielectric constants and conductance values that are different from that of air, the resultant impedance seen by the radio frequency changes whenever material approaches or contacts the sensing region. This influence is measured within the circuitry and compared with the reference point set by the sensitivity adjustment, which determines how much influence must be present before the output changes.

Warranty

N/A Monitor Technologies warrants each proximity switch it manufactures to befreefrom defects in material and workmanship under normal use and service within two (2) years from the date of purchase. The purchaser must give notify Monitor of any defects within the warranty period, return the product intact, and prepay transportation charges. The obligation of Monitor Technologies LLC under this warranty is limited to repair or replacement at its factory. This warranty does not apply to any product which is repaired or altered outside of Monitor Technologies' factory, or which has been subject to misuse, negligence, accident, incorrect wiring by others, or improper installation.

Copyright © 2017 Airmatic Inc.,  All Rights Reserved