The MARTIN® SIX SHOOTER™ Air Cannon System is a state-of-the-art air cannon system that uses a single-air cannon with control unit in place of up to six traditional (tank and valve) air cannons. The system´s one air cannon discharges into one of up to six discharge ports.

The MARTIN® SIX SHOOTER™ System is ideal for installations with multiple discharge points located in close proximity, such as preheater towers, clinker coolers, and other severe condition applications. By separating the air cannon valve from the discharge point, the MARTIN® SIX SHOOTER™ System shelters its working components from dust, gases, and heat conditions, while it simplifies installation and maintenance. The MARTIN® SIX SHOOTER™ can be attached to a vessel using stainless-steel hose, or a combination of hard pipe and stainless-steel hose.
Unit of Measure


Electrical Requirements

N/A 120 VAC, Single Phase 60 Hz from a non-GFCI protected circuit

Power Consumption

N/A 12 VA


N/A 6 outputs for MARTIN® SIX SHOOTER™


N/A 15 Amp On/Off Breaker

Temperature Range

N/A -13° to 130 ºF



Timing Range

N/A Sequential, with from 5 minutes to 99 minutes between discharge

Manual Control

N/A Individual ports can be discharged through the "Mode Selection" screen


N/A Allen-Bradley Micrologix 1100 System with preloaded software

Programming Controller (Keypad)

N/A Allen-Bradley Panel View 300 Micro

External Control Connectability

N/A Built in 10/100 Mbps EtherNet/IP Port and 120 VAC Enable Switch



N/A 16.6 in422 mm


N/A 23 in585 mm


N/A 585 lb265 kg



  • Effective Flow Enhancement
    From one air cannon, the MARTIN® SIX SHOOTER™ boosts flow at up to six points in a vessel.
  • Centralized Maintenance
    Easy access for installation, inspection, and maintenance.
  • Reduced Exposure to Heat and Dust
    By removing the air cannon valve from the discharge point, vital components are placed farther away from excessive heat and dust.
  • Control System
    Each MARTIN® SIX SHOOTER™ comes complete with its own control system.

Control System

N/A Each MARTIN® SIX SHOOTER™ Air Cannon System comes standard with its own control system. The on-board keypad with LCD and preloaded software allows for easy programming of the port firing sequence and firing times. Manual mode can also be selected. The NEMA 4X enclosure is suitable for indoor or outdoor application.

Copyright © 2017 Airmatic Inc.,  All Rights Reserved